DynaFlex™ Hot Melt Adhesive Hose

Key Features of the Dynaflex Hot Melt Hose:

• Outside diameter 30% smaller than hoses made with silicone sponge insulation.
• 17% lower wattage requirements.
• 30% more flexibility.
• Outside temperature 16% cooler.
• Reduced warm-up time.
• 40% less weight.
• One year warranty.
• Competitive replacement hoses available.

Overview

Hot melt adhesive supply hoses are electrically-heated, flexible conduits designed for the transfer of hot-melt adhesive from an adhesive supply unit (ASU) to an applicator (head or handgun).  Hoses are heated by resistance heaters which are wrapped around the hose core and covered with a high temperature insulation.
Hose temperature is regulated by the ASU's controller.  A sensor located in the hose provides temperature information to the controller.

DYNACONTROL are 1000 psi (69 bar) hoses used to deliver hot melt material from a Dynamelt or Dynamini ASU to an ITW Dynatec® applicator (either a dispensing head or a hand-held applicator).  These hoses provide through wiring for power, sensor and chassis ground in the applicator.  All DynaControl hoses feature PT-100 RTD sensors.

Wash down hot melt hose models are available.  They consist of a standard hot melt hose, made water resistant with the addition of a seamless sleeving, sealed end cuffs and liquid-tight electrical conduit and fittings.